Lexus ES: Blind Spot Monitor System (for Gasoline Model)
Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Blind Spot Monitor System (for Gasoline Model)
- Vehicle Speed Sensor (C1A45)
- Yaw Rate Sensor (C1A46)
- Steering Angle Sensor (C1A47)
- Short to +B in Outer Mirror Indicator(Master) (C1AB0)
- Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
- Short to GND in Outer Mirror Indicator(Master) (C1AB2)
- Short to GND in Outer Mirror Indicator(Slave) (C1AB3)
- Open in Outer Mirror Indicator(Master) (C1AB4)
- Open in Outer Mirror Indicator(Slave) (C1AB5)
- Blind Spot Monitor Master Module (C1AB6)
- Blind Spot Monitor Slave Module (C1AB7)
- Destination Information Undefined (C1AB8)
- Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
- Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
- Short to GND or Open in Buzzer (C1ABE)
- Master Module Horizontal Axis Misalignment (C1AC1)
- Slave Module Horizontal Axis Misalignment (C1AC2)
- Customize Parameters
- Customize Parameters
- Data List / Active Test
- Diagnosis System
- Diagnostic Trouble Code Chart
- Freeze Frame Data
- How To Proceed With Troubleshooting
- Parts Location
- Power Source Circuit
- Precaution
- Problem Symptoms Table
- System Description
- System Diagram
- Terminals Of Ecu
- Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129,U0142,U0293)
- Lost Communication with Blind Spot Monitor Slave Module (U0232)
- Lost Communication with Blind Spot Monitor Master Module (U0233)
- Software Incompatibility with Body Control Module "B" (U1331)
READ NEXT:
Vehicle Speed Sensor (C1A45)
DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Conditio
Yaw Rate Sensor (C1A46)
DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication. Blind Spot Monitor Master DTC No. Det
Steering Angle Sensor (C1A47)
DESCRIPTION The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Conditio
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) for RH Side (1) Operate the windshield wiper motor assembly. (2) Stop the windshield wiper motor assembly operation. (3) Check the automatic stop (park) position. HINT: After the front wiper motor is stopped, check the
Rear Wheel House Plate
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 2 ROCKER PANEL MOULDING PROTECTOR *2 CLIP ● Non-reusable part - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMO
© 2016-2026 Copyright www.lexguide.net
