Lexus ES: Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION
This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.
Blind Spot Monitor Master| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1331 | Software Incompatibility with Body Control Module "B" | Destination information of the main body ECU and blind spot monitor sensor do not match |
|
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1331 | Software Incompatibility with Body Control Module "B" | Destination information of the main body ECU and blind spot monitor sensor do not match |
|
CAUTION / NOTICE / HINT
NOTICE:
- When checking for DTCs, make sure that the blind spot monitor system is on.
-
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
Click here
.gif)
PROCEDURE
| 1. | CONFIRM PART NUMBER (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
(a) Check the main body ECU (multiplex network body ECU) part number.
(1) Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.
OK:
The part number is correct.
| NG |  | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
|
| 2. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Blind Spot Monitor Master > Clear DTCs Body Electrical > Blind Spot Monitor Slave > Clear DTCs(b) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC U1331 is output ("Blind Spot Monitor Master") | B |
| DTC U1331 is output ("Blind Spot Monitor Slave") | C |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE BLIND SPOT MONITOR SENSOR RH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR LH |
READ NEXT:
Vehicle Speed Sensor (C1A45)
DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Conditio
Yaw Rate Sensor (C1A46)
DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication. Blind Spot Monitor Master DTC No. Det
SEE MORE:
Image from Camera for Panoramic View Monitor is Abnormal
DESCRIPTION The display signal from each camera is transmitted to the multi-display assembly via the parking assist ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, cor
Terminals Of Ecm
TERMINALS OF ECM ECM HINT: The standard voltage and resistance of each ECM terminal is shown in the table below. In the table, first follow the information under "Condition". Look under "Terminal No. (Symbol)" for the terminals to be inspected. The standard voltage or resistance between the termina
