Lexus ES: Vehicle Speed Sensor (C1A45)
DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
Blind Spot Monitor Master| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU |
|
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK OTHER DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) |
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Chassis > ABS/VSC/TRAC > Trouble CodesOK:
Electronically controlled brake system DTCs are not output.
| NG | .gif) | GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM |
.gif)
|
.gif)
| 2. | CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC C1A45 is output ("Blind Spot Monitor Master") | B |
| DTC C1A45 is output ("Blind Spot Monitor Slave") | C |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE BLIND SPOT MONITOR SENSOR RH |
| C | | REPLACE BLIND SPOT MONITOR SENSOR LH |
READ NEXT:
Yaw Rate Sensor (C1A46)
DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication. Blind Spot Monitor Master DTC No. Det
Steering Angle Sensor (C1A47)
DESCRIPTION The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Conditio
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble A
SEE MORE:
DC/DC Converter Voltage Sensor "A"(VL) Stuck On (P1CB59E)
DTC SUMMARY MALFUNCTION DESCRIPTION If an overvoltage malfunction occurs in the boost converter, the motor generator control ECU (MG ECU) detects the malfunction and stores this DTC. The cause of this malfunction may be one of the following: Internal inverter malfunction
Inverter with converter a
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter. PROCEDURE 1. INSTALL REAR NO. 2
