Lexus ES: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION
This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABB | Blind Spot Monitor Master Module Beam Axis Inspection Incomplete | A beam axis inspection has not been performed | Blind spot monitor sensor RH |
PROCEDURE
| 1. | PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION) |
(a) Change the blind spot monitor sensor RH to Test Mode using the Techstream.
HINT:
Refer to Blind Spot Monitor Beam Axis Inspection.
Click here .gif)
| NEXT |  | END |
READ NEXT:
Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The
Short to GND or Open in Buzzer (C1ABE)
DESCRIPTION
DTC C1ABE is stored when the blind spot monitor sensor LH detects a short to ground or open in the RCTA buzzer (blind spot monitor buzzer) circuit.
DTC No. Detection Item DTC
Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer teste
SEE MORE:
Lost Communication with Cruise Control Module Missing Message (U010487)
DESCRIPTION The millimeter wave radar sensor assembly communicates with the forward recognition camera via CAN communication. If a communication error is detected between the forward recognition camera and millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores this D
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System (for Gasoline Model)
