Lexus ES: Wiper And Washer System (for Gasoline Model)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System (for Gasoline Model)
- Precaution
- Parts Location
- System Description
- System Diagram
- Check For Intermittent Problems
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Utility
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with Wiper ECU LIN (B1245)
- Lost Communication with Humidity/Rain Sensor LIN (B1279)
- ECU Malfunction (B1370)
- Wiper Switch Signal Mismatch between LIN and Line (B1372)
- Lost Communication with Wiper System LIN BUS (B1373)
- Rain Sensor Malfunction (B1400)
- Wiper Motor Power Source Circuit
- Wiper and Washer Switch Circuit
- Washer Motor Circuit
- Washer Fluid Level Warning Switch Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
Parts Location
PARTS LOCATION ILLUSTRATION *A w/ Auto Wiper System - - *1 WINDSHIELD WIPER MOTOR ASSEMBLY *2 RAIN SENSOR *3 LEVEL WARNING SWITCH ASSEMBLY *4 WINDSHIELD WASHER MOTOR AND
System Description
SYSTEM DESCRIPTION FRONT WIPER AND WASHER CONTROL FUNCTION Control/Function Description Wiper speed regulation Maintains the default speed of the wipers even when the supply voltage or resi
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT OIL PUMP RELIEF VALVE (a) Coat the oil pump relief valve with engine oil, then check that it falls smoothly into the valve hole by its own weight. HINT: If the oil pump relief valve does not fall smoothly, replace the oil pump assembly. 2. INSPECT OIL P
Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
DESCRIPTION Depending on the malfunction, the skid control ECU (brake booster with master cylinder assembly) prohibits operation of the electronically controlled brake system to protect components and prevent incorrect operation when DTCs are stored. If the switching solenoid is disabled due to proh
© 2016-2026 Copyright www.lexguide.net
