Lexus ES manuals

Lexus ES: Utility

UTILITY

OPERATION HISTORY

HINT:

History of Reason for Operation: The windshield wiper motor assembly stores Operation History which can be read using the Techstream, when a malfunction of the wiper and washer system occurs.

Click here

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Wiper / Utility.

(e) Following the instructions on the screen, save the Operation History.

Body Electrical > Wiper > Utility

Tester Display

Operation History

WIPER SPECIFICATION SWITCH

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Steering Angle Sensor / Utility.

(e) According to the display on the Techstream, select Wiper Specification Switch.

Chassis > Steering Angle Sensor > Utility

Tester Display

Wiper Specification Switch

READ NEXT:

 Terminals Of Ecu

TERMINALS OF ECU CHECK WINDSHIELD WIPER MOTOR ASSEMBLY (a) Disconnect the A38 windshield wiper motor assembly connector. (b) Measure the voltage and resistance on the wire harness side connector acco

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a DTC is detected, the windshield wiper motor assembly stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the T

SEE MORE:

 Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below

 Emergency Call Switch Circuit Short to Ground (B15C511,B15C513)

DESCRIPTION If the DCM (telematics transceiver) detects an error in the communication between the DCM (telematics transceiver) and the map light sub-assembly (manual (SOS) switch) as a result of the DCM (telematics transceiver) self check, this DTC will be stored. DTC No. Detection Item DTC D

© 2016-2026 Copyright www.lexguide.net