Lexus ES manuals

Lexus ES: ECU Malfunction (B1370)

DESCRIPTION

This DTC is stored when the windshield wiper motor assembly detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Memory

DTC Output from

B1370

ECU Malfunction

  • Battery voltage is 9.5 V or more
  • A malfunction is detected for during the windshield wiper motor assembly self-check.
  • 10 seconds or more

Windshield wiper motor assembly

Windshield wiper motor assembly

PROCEDURE

1.

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Wiper / Trouble Codes.

(e) Clear the DTCs.

Body Electrical > Wiper > Clear DTCs
NEXT

2.

CHECK FOR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Wait 10 seconds or more.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Wiper / Trouble Codes.

(f) Check for DTCs.

Body Electrical > Wiper > Trouble Codes

Result

Proceed to

DTC B1370 is not output

A

DTC B1370 is output

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE WINDSHIELD WIPER MOTOR ASSEMBLY

READ NEXT:

 Wiper Switch Signal Mismatch between LIN and Line (B1372)

DESCRIPTION Under normal operation, the windshield wiper motor assembly receives operation signals from the windshield wiper switch assembly via LIN communication. The windshield wiper motor assembly

 Lost Communication with Wiper System LIN BUS (B1373)

DESCRIPTION The main body ECU (multiplex network body ECU) and windshield wiper motor assembly communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if comm

 Rain Sensor Malfunction (B1400)

DESCRIPTION This DTC is stored when the rain sensor detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from B1400 Rain Se

SEE MORE:

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE SHIFT POSITION INDICATOR (a) Disengage the 2 clamps to disconnect the wire harness. (b) Remove the 2 screws. (c) Disengage the claw and guide and remove the shift position indicator from the rear upper console panel sub-assembly.

 Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)

DESCRIPTION Refer to DTCs C1415 and C1416. Click here DTC No. Detection Item INF Code DTC Detection Condition Trouble Area MIL Note C1407 Open or Short in Rear Speed Sensor RH Circuit 523 526 528 INF Code: 523 An open in the speed sensor signal circuit continues for

© 2016-2025 Copyright www.lexguide.net