Lexus ES: 2gr-fks (engine Control)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / 2gr-fks (engine Control)
- Accelerator Pedal
- Active Control Engine Mount (for Front Side)
- Active Control Engine Mount(for Rear Side)
- Air Fuel Ratio Sensor
- Camshaft Oil Control Solenoid
- Camshaft Oil Control Valve (for Exhaust Side Of Bank 1)
- Camshaft Oil Control Valve (for Exhaust Side Of Bank 2)
- Camshaft Oil Control Valve (for Intake Side Of Bank 1)
- Camshaft Oil Control Valve (for Intake Side Of Bank 2)
- Camshaft Position Sensor
- Crankshaft Position Sensor
- Ecm
- Engine Coolant Temperature Sensor
- Heated Oxygen Sensor
- Ignition Coil And Spark Plug
- Ignition System
- Knock Sensor
- Mass Air Flow Meter
- Relay
- Sfi System
- Throttle Body
- Vacuum Switching Valve (for Engine Mounting)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for TMK Made *B for TMMK Made *1 ACCELERATOR PEDAL ASSEMBLY *2 ACCELERATOR PEDAL PAD *3 ACCELERATOR PEDAL SENSOR ASSEMBLY *4 NO. 1 INSTRUMENT P
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the follo
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE:
Do not remove the generator pulley cap.
If the generator pulley cap is removed, replace the generator pulley cap and generator pulley with clutch with new ones as the correct grease amount cannot be confirmed.
HINT: If it is confirmed tha
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor assembly removal/installation are shown below. Necessary Procedure After P
© 2016-2026 Copyright www.lexguide.net
