Lexus ES: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.
Powertrain > Engine > Data List| Tester Display |
|---|
| Accelerator Position Sensor No.1 Voltage |
| Accelerator Position Sensor No.2 Voltage |
(e) Read the values displayed on the Techstream.
Standard Voltage:
| Techstream Display | Condition | Specified Condition |
|---|---|---|
| Accelerator Position Sensor No. 1 Voltage | Accelerator pedal fully released | 0.5 to 1.1 V |
| Accelerator pedal fully depressed | 2.6 to 4.5 V | |
| Accelerator Position Sensor No. 2 Voltage | Accelerator pedal fully released | 1.2 to 2.0 V |
| Accelerator pedal fully depressed | 3.4 to 4.75 V |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 2. REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY NOTICE:
Avoid physical shock to the accelerator pedal se
Installation
INSTALLATION PROCEDURE 1. INSTALL ACCELERATOR PEDAL ASSEMBLY (a) Engage the claw to install the accelerator pedal assembly. (b) Install the 2 bolts. Torque: 7.5 N·m {76 kgf·cm, 66 in
SEE MORE:
Inspection Mode Procedure
INSPECTION MODE PROCEDURE
INSPECTION MODE (for HV Model)
NOTICE:
When operating the vehicle in an inspection mode for an operation such as a speedometer
test, a DTC may be stored. Therefore, if the warning light illuminates, check for
DTCs using the Techstream and clear the DTCs.
HINT:
If t
Hybrid/EV Battery Sensor Module (P0AFC00,P0AFC16,P0AFC96,P308A12)
DESCRIPTION If the battery voltage sensor detects an internal malfunction, it sends an error signal to the hybrid vehicle control ECU. When the hybrid vehicle control ECU receives the error signal from the battery voltage sensor, the ECU warns the driver and performs fail-safe control. DTC No.
