Lexus ES: Ignition Coil And Spark Plug
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / 2gr-fks (engine Control) / Ignition Coil And Spark Plug
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 IGNITION COIL ASSEMBLY *2 SPARK PLUG *3 V-BANK COVER SUB-ASSEMBLY *4 VACUUM HOSE N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ign
Installation
INSTALLATION PROCEDURE 1. INSTALL SPARK PLUG Click here 2. INSTALL IGNITION COIL ASSEMBLY HINT: Perform "Inspection After Repair" after replacing an ignition coil assembly. Click here (a) Install
SEE MORE:
Components
COMPONENTS ILLUSTRATION *A for A25A-FXS, A25A-FKS *B for 2GR-FKS *C Type A *D Type B *1 FRONT FENDER APRON SEAL LH *2 FRONT FLOOR COVER LH *3 FRONT WHEEL OPENING EXTENSION PAD LH *4 FRONT WHEEL OPENING EXTENSION PAD RH *5 NO. 1 ENGINE UNDER COVER *6
Check Bus 4 Lines for Short Circuit
DESCRIPTION There may be a short circuit between the CAN main bus lines and/or CAN branch lines when the resistance between terminals 22 (CA2H) and 7 (CA2L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area Resistance between terminals 22 (CA2H) and 7 (CA
© 2016-2025 Copyright www.lexguide.net
