Lexus ES: Knock Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 KNOCK CONTROL SENSOR (for Bank 1) *2 KNOCK CONTROL SENSOR (for Bank 2) N*m (kgf*cm, ft.*lbf): Specified torque * For use with a union nut wrench
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knoc
Inspection
INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Cond
SEE MORE:
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR TUBE
(a) Engage the clamp to install the air delivery way to the intake air
surge tank assembly.
(b) Install the 2 clips to the air tube.
(c) Connect the air tube to the air delivery w
ABS Pump Motor Supply Voltage Circuit Short to Ground or Open (C052F14)
DESCRIPTION The ABS motor relay is built into the brake actuator assembly. When the skid control ECU (brake actuator assembly) operates ABS, TRAC, VSC, brake hold, or brake assist, the ABS motor relay turns ON and drives the motor pump built into the brake actuator assembly. DTC No. Detection I
© 2016-2026 Copyright www.lexguide.net
