Lexus ES: Wiper And Washer System (for Gasoline Model)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Wiper / Washer / Wiper And Washer System (for Gasoline Model)
- Precaution
- Parts Location
- System Description
- System Diagram
- Check For Intermittent Problems
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Utility
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication with Wiper ECU LIN (B1245)
- Lost Communication with Humidity/Rain Sensor LIN (B1279)
- ECU Malfunction (B1370)
- Wiper Switch Signal Mismatch between LIN and Line (B1372)
- Lost Communication with Wiper System LIN BUS (B1373)
- Rain Sensor Malfunction (B1400)
- Wiper Motor Power Source Circuit
- Wiper and Washer Switch Circuit
- Washer Motor Circuit
- Washer Fluid Level Warning Switch Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
Parts Location
PARTS LOCATION ILLUSTRATION *A w/ Auto Wiper System - - *1 WINDSHIELD WIPER MOTOR ASSEMBLY *2 RAIN SENSOR *3 LEVEL WARNING SWITCH ASSEMBLY *4 WINDSHIELD WASHER MOTOR AND
System Description
SYSTEM DESCRIPTION FRONT WIPER AND WASHER CONTROL FUNCTION Control/Function Description Wiper speed regulation Maintains the default speed of the wipers even when the supply voltage or resi
SEE MORE:
High Voltage Power Resource Circuit Short during Ready ON (P1C8449)
DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU monitors the high-voltage wiring between the HV battery and inverter with converter assembly and detects an open circuit malfunction. HINT:
This DTC is differentiated from P300449 based on detection timing (after power switch is t
Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL ECU HINT: If the results of the following inspections are as specified but a malfunction has occurred, replace the shift lock control unit assembly. (a) Inspect wire harness: (1) Disconnect the shift lock control ECU connector. (2)
© 2016-2026 Copyright www.lexguide.net
