Lexus ES: Rain Sensor Malfunction (B1400)
DESCRIPTION
This DTC is stored when the rain sensor detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1400 | Rain Sensor Malfunction |
| Rain sensor | ○ | Rain sensor |
PROCEDURE
| 1. | CLEAR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Rain and/or Humidity Sensor / Trouble Codes.
(e) Clear the DTCs.
Body Electrical > Rain and/or Humidity Sensor > Clear DTCs
|
.gif)
| 2. | CHECK FOR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Wait 10 seconds or more.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Rain and/or Humidity Sensor / Trouble Codes.
(f) Check for DTCs.
Body Electrical > Rain and/or Humidity Sensor > Trouble Codes| Result | Proceed to |
|---|---|
| DTC B1400 is not output | A |
| DTC B1400 is output | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE RAIN SENSOR |
READ NEXT:
Wiper Motor Power Source Circuit
DESCRIPTION This circuit is the power source circuit for the windshield wiper motor assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Inspect the fuses of circuits related to this system be
Wiper and Washer Switch Circuit
DESCRIPTION The condition of the windshield wiper switch assembly is detected and sent to the steering sensor in this circuit. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Con
Washer Motor Circuit
DESCRIPTION When the windshield washer motor and pump assembly receives signals from the windshield wiper switch assembly it operates to spray washer fluid from the washer nozzle sub-assemblies. WIRIN
SEE MORE:
Illumination Circuit
DESCRIPTION Power is supplied to the radio receiver assembly and steering pad switch assembly illumination when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
The vehicle is equipped with a Supplemental Restraint System (SRS) which includ
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY (a) Apply high-temperature grease to the pinion drive lever. High-temperature Grease HINT: Apply approximately 0.1 g of high-temperature grease to each section. (b) Align the cutout of the starter drive housing a
