Lexus ES manuals

Lexus ES: Dtc Check / Clear

Lexus ES (XZ10) Service Manual / Vehicle Interior / Wiper / Washer / Wiper And Washer System (for Gasoline Model) / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Wiper > Trouble Codes Body Electrical > Main Body > Trouble Codes Body Electrical > Rain and/or Humidity Sensor > Trouble Codes

(e) Check for DTCs.

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

Body Electrical > Wiper > Clear DTCs Body Electrical > Main Body > Clear DTCs Body Electrical > Rain and/or Humidity Sensor > Clear DTCs

(e) Clear the DTCs.

READ NEXT:

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a DTC is detected, the windshield wiper motor assembly stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the T

 Fail-safe Chart

FAIL-SAFE CHART PROTECTION FUNCTION (a) The windshield wiper motor assembly operates the following protection functions if it detects an abnormal condition, in order to protect the wiper and washer sy

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

SEE MORE:

 Lack of Power

DESCRIPTION Problem Symptom Suspected Area Trouble Area Engine speed fluctuation due to abnormal combustion Idle speed too low or high Strong engine vibration due to above symptoms Ignition malfunction Deviation in air fuel ratio (Excessive or insufficient intake air volume

 Sub Radiator

ComponentsCOMPONENTS ILLUSTRATION *1 RADIATOR ASSEMBLY - - RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly remov

© 2016-2026 Copyright www.lexguide.net