Lexus ES: Customize Parameters
Lexus ES (XZ10) Service Manual / Vehicle Interior / Wiper / Washer / Wiper And Washer System (for Gasoline Model) / Customize Parameters
CUSTOMIZE PARAMETERS
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
CUSTOMIZE WIPER AND WASHER SYSTEM (w/ Auto Wiper System)
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Utility / Customize / Wiper.
(5) Select the setting by referring to the table below.
Wiper| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Auto Wiper | Function to enable AUTO wiper operation | Avail | 0:Avail,1:Not Avl | Rain Sensor |
HINT:
Changes to the customize settings will not be applied until the engine switch is turned off then ON.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. Click here HINT:
Use the table below to help determine the cause of proble
Utility
UTILITY OPERATION HISTORY HINT: History of Reason for Operation: The windshield wiper motor assembly stores Operation History which can be read using the Techstream, when a malfunction of the wiper an
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER MOTOR ASSEMBLY (a) Disconnect the A38 windshield wiper motor assembly connector. (b) Measure the voltage and resistance on the wire harness side connector acco
SEE MORE:
Brake System (P157800)
DESCRIPTION When a malfunction in the electronically controlled brake system is detected, DTC P157800 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from P157800 Brake System When the engine switch is on (IG) and the dynamic radar cruise co
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL VACUUM HOSE (a) Install the vacuum hose to the intake manifold. 2. INSTALL NO.
© 2016-2026 Copyright www.lexguide.net
