Lexus ES: Lighting (ext)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Lighting (ext)
- Automatic Light Control Sensor
- Hazard Warning Switch
- Headlight Assembly (for Bulb Type Turn Signal Light)
- Headlight Assembly (for Led Type Turn Signal Light)
- Headlight Dimmer Switch
- Headlight Ecu
- Height Control Sensor
- High Mounted Stop Light Assembly
- Illumination Light Assembly (for Front Door)
- Illumination Light Assembly (for Rear Door)
- License Plate Light Assembly
- Lighting System (for Gasoline Model)
- Lighting System (for Hv Model)
- Rear Combination Light Assembly
- Rear Light Assembly
- Relay
- Side Turn Signal Light Assembly
- Stop Light Switch
- Switch Housing
READ NEXT:
Automatic Light Control Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 AUTOMATIC LIGHT CONTROL SENSOR *2 NO. 1 SPEAKER OPENING COVER ASSEMBLY On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIG
Components
COMPONENTS ILLUSTRATION *A w/o Headup Display *B w/ Headup Display *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR OPENING TRIM COVER LH *3 FRONT DOOR SCUFF PLATE LH *4 HAZARD W
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proce
Operation Check
OPERATION CHECK CHECK WINDSHIELD DEICER SYSTEM (a) Turn the power switch on (IG). (b) Check that the windshield deicer wire (windshield glass) becomes warm by operating the front wiper deicer switch. (c) Confirm that windshield deicer system operation stops after approximately 15 minutes. NOTICE: If
© 2016-2026 Copyright www.lexguide.net
