Lexus ES: Illumination Light Assembly (for Rear Door)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Lighting (ext) / Illumination Light Assembly (for Rear Door)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COURTESY LIGHT ASSEMBLY *2 REAR DOOR ILLUMINATION LIGHT (REAR DOOR OUTSIDE HANDLE ASSEMBLY) *3 REAR DOOR SERVICE HOLE COVER *4 REAR DOOR TRIM BOARD SUB-A
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR DOOR ILLUMINATION LIGHT LH (REAR DOOR OUTSIDE HANDLE ASSEMBLY LH) *a Component without harness connected (Rear Door Illumination Light LH (Rear Door Outside
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL VISOR COVER ASSEMBLY (a) Install the visor cover assembly to the outer mirror actuator assembly. 2. INSTALL OUTER MIRROR UPPER COVER
Test Mode Procedure
TEST MODE PROCEDURE NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) ins
© 2016-2026 Copyright www.lexguide.net
