Lexus ES: Rear Combination Light Assembly
Lexus ES (XZ10) Service Manual / Vehicle Interior / Lighting (ext) / Rear Combination Light Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 LUGGAGE COMPARTMENT FLOOR MAT *2 SPARE WHEEL COVER TRAY ILLUSTRATION *1 REAR FLOOR FINISH PLATE *2 LUGGAGE HOLD BELT STRIKER ASSEMBLY ILLUSTRATION
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rea
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT LENS AND BODY LH (for TMC Made) *a Component without harness connected (Rear Combination Light Lens and Body LH) (a) Apply auxiliary bat
SEE MORE:
High Beam Headlight Circuit
DESCRIPTION The headlight ECU sub-assembly controls the high beam headlights. WIRING DIAGRAM except Bulb Type Turn Signal Light (for TMMK Made) for Bulb Type Turn Signal Light (for TMMK Made) CAUTION / NOTICE / HINT NOTICE:
If the headlight ECU sub-assembly LH has been replaced, it is necessary
Terminals Of Ecu
TERMINALS OF ECU NOTICE:
Turning the power switch on (IG) with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed.
Do not apply excessive force to the millimeter wave radar sensor assembly connector.
CHECK MILLIMETER WAVE RAD
© 2016-2026 Copyright www.lexguide.net
