Lexus ES: Adaptive Variable Suspension System
Lexus ES (XZ10) Service Manual / Suspension / Suspension Control / Adaptive Variable Suspension System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Customize Parameters
- Test Mode Procedure
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Front Acceleration Sensor RH Malfunction (C1715-C1717,C1796-C1798)
- Diagnostic Trouble Code Chart
- FR Damping Force Control Actuator Circuit (C1731-C1734)
- Suspension Control ECU Malfunction (C1781)
- Front Wheels Speed Sensor Signal Malfunction (C1783)
- Steering Sensor Signal Malfunction (C1784)
- Master Cylinder Pressure Circuit (C1786)
- (Horizontality) G Sensor Malfunction (C1787)
- Vehicle Identification Malfunction (C1789)
- Lost Communication With ECM/PCM "A" (U0100-U0122,U0124,U0126,U1103)
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT ABSORBER CONTROL ACTUATOR RH (FRONT SHOCK ABSORBER ASSEMBLY RH) *2 FRONT ABSORBER CONTROL ACTUATOR LH (FRONT SHOCK ABSORBER ASSEMBLY LH) *3 REAR AB
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
automatic transaxle fluid replacement are shown below.
Necessary Procedures After Parts Remov
Height Sensor Initialization Incomplete (B2450)
DESCRIPTION The headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after it was replaced. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from B2450 Height Sensor Initialization Incomplete
The power switch is on (IG).
© 2016-2026 Copyright www.lexguide.net
