Lexus ES: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Air suspension / Trouble Codes.
Chassis > Air suspension > Trouble CodesHINT:
When freeze frame data is stored, check the freeze frame data.
Click here .gif)
(f) Read the DTCs by following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
(g) Refer to Diagnostic Trouble Code Chart for DTC information.
Click here
CLEAR DTC
HINT:
After repairing the malfunctions, clear the DTCs.
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Air suspension / Trouble Codes.
Chassis > Air suspension > Clear DTCsNOTICE:
DTCs and freeze frame data are cleared at the same time.
(f) Clear the DTCs by following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) The absorber control ECU stores system condition information as freeze frame data the moment a DTC is stored. The Freeze Frame Data can be displayed using the T
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE CHART Adaptive Variable Suspension System DTC Chart Malfunction Item Fail-safe Operation C1715 C1716 C1717 Acceleration sensor circuit Partial control continue
Data List / Active Test
DATA LIST / ACTIVE TEST READ DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether
SEE MORE:
CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION The headlight ECU sub-assembly LH or headlight ECU sub-assembly RH stores this DTC if it detects an internal malfunction related to the CAN communication system. for LED Type Turn Signal Light DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U100
Initialization
INITIALIZATION RESET BACK-UP BATTERY CONDITION HINT: If the back-up battery (mobilephone battery) has been replaced, it is necessary to perform the Reset Backup Battery Condition procedure. (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Ch
