Lexus ES: Suspension Control
Lexus ES (XZ10) Service Manual / Suspension / Suspension Control
- Absorber Control Actuator(for Front Side)
- Absorber Control Actuator(for Rear Side)
- Absorber Control Switch
- Adaptive Variable Suspension System
- Front Acceleration Sensor
- Relay
- Suspension Control Ecu
READ NEXT:
Absorber Control Actuator(for Front Side)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester C
Absorber Control Actuator(for Rear Side)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester C
Absorber Control Switch
ComponentsCOMPONENTS ILLUSTRATION *1 DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) - - RemovalREMOVAL PROCEDURE 1. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU MULTIPLEX TILT AND TELESCOPIC ECU *a Component with harness connected (Multiplex Tilt and Telescopic ECU) - - (a) Measure the voltage and resistance according to the value(s) in the table below. HINT: Inspect the connectors from the back side while the connectors are co
Inspection
INSPECTION PROCEDURE 1. INSPECT OIL PUMP RELIEF VALVE (a) Coat the oil pump relief valve with engine oil, then check that it falls smoothly into the valve hole by its own weight. HINT: If the oil pump relief valve does not fall smoothly, replace the oil pump assembly. 2. INSPECT OIL P
© 2016-2026 Copyright www.lexguide.net
