Lexus ES: Customize Parameters
Lexus ES (XZ10) Service Manual / Suspension / Suspension Control / Adaptive Variable Suspension System / Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE ADAPTIVE VARIABLE SUSPENSION SYSTEM
HINT:
"Custom" mode can be selected by using the drive mode select switch (combination switch assembly).
(a) Customizing with the multi-display
(1) Turn the engine switch on (IG).
(2) Enter the following menus: MENU / Setup / Vehicle / Vehicle Customization / Drive Mode Customization.
(3) Select the setting by referring to the table below.
| Display | Content | Default | Setting |
|---|---|---|---|
| Powertrain | Acceleration response, etc. | Normal | Power / Normal / Eco |
| Chassis | Damping force of suspension, steering assist force, etc. | Normal | Sport / Normal |
| Climate | Effectiveness of air conditioning system, etc. | Normal | Normal / Eco |
READ NEXT:
Test Mode Procedure
TEST MODE PROCEDURE TEST MODE PROCEDURE NOTICE: After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification informat
Terminals Of Ecu
TERMINALS OF ECU CHECK ABSORBER CONTROL ECU (a) Measure the voltage and resistance according to the value(s) in the table below. NOTICE: Inspect the connectors from the back side while the connectors
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: C
SEE MORE:
Tire Pressure Monitor Receiver Communication Stop (B1247)
DESCRIPTION The main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver communicate by direct line. If a malfunction occurs in this communication signal, B1247 is output by the main body ECU (multiplex network body ECU). DTC No. Detection Item DTC Detection Condi
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER MOTOR ASSEMBLY (a) Disconnect the A38 windshield wiper motor assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Descrip
© 2016-2026 Copyright www.lexguide.net
