Lexus ES: Performance Damper
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for A25A-FXS *B for 2GR-FKS *1 REAR FLOOR SIDE MEMBER COVER *2 REAR NO. 1 FLOOR BOARD *3 SUSPENSION TOWER DAMPER - - N*m (kgf*cm, ft.*lb
Components
COMPONENTS ILLUSTRATION *A for A25A-FKS *B for A25A-FXS *C for 2GR-FKS - - *1 REAR FLOOR SIDE MEMBER COVER *2 REAR NO. 1 FLOOR BOARD *3 SUSPENSION TOWER DAMPER -
Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 1 FLOOR BOARD (for 2GR-FKS) (a) Remove the 4 clips (A). (b) Disengage the 3 grommets (B) and 2 clips (C) to remove the rear No. 1 floor board. 2. RE
SEE MORE:
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
automatic transaxle fluid replacement are shown below.
Necessary Procedures After Parts Remov
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL HEADLIGHT SEAL (for TMC Made) HINT: Perform this procedure only when replacement of the headlight seal is necessary. (a) Clean the ins
© 2016-2025 Copyright www.lexguide.net
