Lexus ES: Inspection
INSPECTION
PROCEDURE
1. INSPECT SUSPENSION TOWER DAMPER
(a) Visually check the suspension tower damper and, if the rod is bent, a leak is found or the damper cannot be installed without extending or compressing it, replace it with a new one.
NOTICE:
Do not extend or compress the damper.
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Using a union nut wrench, install the suspension tower damper to the vehicle with the 2 nuts. Torque: Specified tightening torque : 3
Installation
INSTALLATION PROCEDURE 1. INSTALL SUSPENSION TOWER DAMPER (a) Using a union nut wrench, install the suspension tower damper to the vehicle with the 2 nuts. Torque: Specified tightening torque : 3
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF SUSPENSION TOWER DAMPER (a) Using a hacksaw, make a hole in the cylinder between (A) and (B) shown in the illustration to discharge the gas inside. *a 10 mm
SEE MORE:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Lane Control System Pre-collision S
Components
COMPONENTS ILLUSTRATION *1 HEADLIGHT ECU SUB-ASSEMBLY *2 HEADLIGHT GASKET ● Non-reusable part - -
© 2016-2026 Copyright www.lexguide.net
