Lexus ES: Generator
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL GENERATOR ASSEMBLY (a) Install the generator assembly with the bolt and 2 nuts. Torque: 25 N·m {255 kgf·cm, 18 ft·lbf} (b) Engage the clamp. (c) Connect the E.F.I
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL GENERATOR ROTOR BEARING (a) Using SST and a press, install a new generator rotor bearing. SST: 09950-60011 09951-00470 SST: 09950-70010 09951-07100 (b
Inspection
INSPECTION PROCEDURE 1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY (a) Using a vernier caliper, measure the length of the exposed brushes. Standard Exposed Brush Length: 9.5 to 11.5 mm (0.374 to 0.45
SEE MORE:
System Diagram
SYSTEM DIAGRAM *1 Purge Valve (Purge VSV) *2 Fuel Tank Cap Assembly *3 Fuel Tank Assembly *4 Canister Filter *5 Fuel Cut-off Valve *6 ECM *7 Canister Pump Module (Leak Detection Pump Sub-assembly) *8 Pump Motor *9 Canister Pressure Sensor *10 Vent Va
Installation
INSTALLATION PROCEDURE 1. INSTALL HYBRID BATTERY THERMISTOR CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Engage the 3 claws of the hybrid battery thermistor (sensor portions) to install the hybrid battery thermistor to the HV battery. HINT: Install each hybrid battery the
© 2016-2026 Copyright www.lexguide.net
