Lexus ES: Exterior Panels / Trim
Lexus ES (XZ10) Service Manual / Vehicle Interior / Exterior Panels / Trim
- Black Out Tape (for Front Door)
- Black Out Tape (for Rear Door)
- Front Bumper
- Front Door Belt Moulding
- Front Door Window Frame Moulding
- Front Pillar Upper Cover
- Grille Shutter
- Grille Shutter System
- Luggage Compartment Door Outside Garnish
- Name Plate
- Quarter Garnish
- Rear Bumper (for Dual Type)
- Rear Bumper (for Single Type)
- Rear Door Belt Moulding
- Rear Door Window Frame Moulding
- Rear Spoiler
- Rear Wheel House Plate
- Rocker Panel Moulding
- Roof Drip Side Finish Moulding
- Windshield Outside Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 MULTIPLEX NETWORK MASTER SWITCH ASS
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during bla
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (a) Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT LENS AND BODY LH (for TMC Made) *a Component without harness connected (Rear Combination Light Lens and Body LH) (a) Apply auxiliary battery voltage to the rear combination light lens and body LH and check that the lights illuminate. OK
© 2016-2026 Copyright www.lexguide.net
