Lexus ES: Rear Spoiler
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Power Trunk Lid System *B for TMMK Made *1 LUGGAGE COMPARTMENT DOOR COVER *2 LUGGAGE LOCK CONTROL CABLE PLATE *3 REAR SPOILER SUB-ASSEMBLY *4
Removal
REMOVAL PROCEDURE 1. REMOVE LUGGAGE LOCK CONTROL CABLE PLATE Click here 2. REMOVE SWITCH BEZEL (w/ Power Trunk Lid System) Click here 3. REMOVE LUGGAGE COMPARTMENT DOOR COVER Click here 4. REMOV
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SPOILER SUB-ASSEMBLY HINT: When installing a new rear spoiler sub-assembly, heat the luggage compartment door panel and rear spoiler sub-assembly using a heat li
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING WHEEL SWITCH HOUSING *a Component without harness connected (Steering Wheel Switch Housing) - - (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Light Switch Circuit Tester Connection Condition
Charging
CHARGING CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when charging the HV battery are shown below. Necessary Procedures After Parts Removed/Installed/Replaced R
© 2016-2025 Copyright www.lexguide.net
