Lexus ES: Rear Bumper (for Single Type)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Exterior Panels / Trim / Rear Bumper (for Single Type)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR BUMPER ASSEMBLY *2 REAR COMBINATION LIGHT COVER LH *3 REAR COMBINATION LIGHT COVER RH - - ILLUSTRATION *A w/ Hands Free Power Trunk Lid -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rea
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE KICK DOOR CONTROL SENSOR WITH BRACKET (w/ Hands Free Power Trunk Lid) Click here 2. REMOVE REAR CENTER ULTRASONIC SENSOR (w/ Parking Support Alert System) Click her
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disconnect the wire harness protector. *1 Wire Harness Protector (b) Disconnect the engine oil pressure switch assembly connector. (c) Start the engine. (d) Measure the resist
System Diagram
SYSTEM DIAGRAM *1 Purge Valve (Purge VSV) *2 Fuel Tank Cap Assembly *3 Fuel Tank Assembly *4 Canister Filter *5 Fuel Cut-off Valve *6 ECM *7 Canister Pump Module (Leak Detection Pump Sub-assembly) *8 Pump Motor *9 Canister Pressure Sensor *10 Vent Va
© 2016-2026 Copyright www.lexguide.net
