Lexus ES: Front Pillar Upper Cover
Lexus ES (XZ10) Service Manual / Vehicle Interior / Exterior Panels / Trim / Front Pillar Upper Cover
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 MULTIPLEX NETWORK MASTER SWITCH ASS
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE NO. 2 DOOR TRIM PAD Click here 2.
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR FRONT LOWER FRAME UPP
SEE MORE:
Hybrid/EV Battery Sensor Module Signal Compare Failure (P0AFC62,...,P308A13)
DESCRIPTION Refer to the description for DTC P1AC000. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0AFC62 Hybrid/EV Battery Sensor Module Signal Compare Failure The difference between the voltage output by detection circuit C and
Test Mode Procedure
TEST MODE PROCEDURE TEST MODE (SIGNAL CHECK MODE) PROCEDURE HINT:
When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
After the tire pressure warning ECU and receiver completes the signal check for each ins
© 2016-2026 Copyright www.lexguide.net
