Lexus ES: Exterior Panels / Trim
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Exterior Panels / Trim
- Black Out Tape (for Front Door)
- Black Out Tape (for Rear Door)
- Front Bumper
- Front Door Belt Moulding
- Front Door Window Frame Moulding
- Front Pillar Upper Cover
- Grille Shutter
- Grille Shutter System
- Luggage Compartment Door Outside Garnish
- Name Plate
- Quarter Garnish
- Rear Bumper (for Dual Type)
- Rear Bumper (for Single Type)
- Rear Door Belt Moulding
- Rear Door Window Frame Moulding
- Rear Spoiler
- Rear Wheel House Plate
- Rocker Panel Moulding
- Roof Drip Side Finish Moulding
- Windshield Outside Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 MULTIPLEX NETWORK MASTER SWITCH ASS
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during bla
SEE MORE:
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
When replacing the radio receiver assembly, always re
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING WHEEL SWITCH HOUSING *a Component without harness connected (Steering Wheel Switch Housing) - - (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Light Switch Circuit Tester Connection Condition
© 2016-2026 Copyright www.lexguide.net
