Lexus ES: Front Bumper
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 FRONT BUMPER ASSEMBLY *3 FRONT BUMPER SIDE MOUNTING BRACKET - - ILLUSTRATION *A for Bar Type Radiator Grille -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during fro
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (for Bar Type Radiator Grille) (a) Remove the 2 screws. (b) Disengage the 4 claws to remove the front bumper exte
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY CAUTION: Perform the inspection in a well-ventilated area. Do not perform the inspection near an open flame. (a) Check that the float moves smoothly between F and E. (b) Check the fuel sender gauge assembly voltage. (1) Apply 5 V between
Initialization
INITIALIZATION INITIALIZE PARKING ASSIST MONITOR SYSTEM (a) When "!" mark is displayed on the image of the area behind the vehicle, perform the following procedure to correct the steering angle neutral point. (1) Fully turn the steering wheel to the right and left on flat ground. NOTICE: Memorizing
© 2016-2025 Copyright www.lexguide.net
