Lexus ES: Suspension Control Ecu
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Type A *B for Type B *1 LUGGAGE COMPARTMENT FLOOR MAT *2 LUGGAGE COMPARTMENT TRIM COVER RH *3 LUGGAGE COMPARTMENT TRIM INNER COVER RH *4 RE
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during abso
Installation
INSTALLATION PROCEDURE 1. INSTALL ABSORBER CONTROL ECU (a) Install the absorber control ECU with the 2 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} NOTICE:
Avoid any impact to the absorber cont
SEE MORE:
Engine Coolant Temperature Sensor 1 Circuit Short to Battery or Open (P011515)
DESCRIPTION Refer to DTC P011511. Click here HINT: When DTC P011515 is stored, the ECM enters fail-safe mode. During fail-safe mode, the engine coolant temperature is estimated to be 80°C (176°F) by the ECM. Fail-safe mode continues until a pass condition is detected. DTC No. Detection Item
Installation
INSTALLATION PROCEDURE 1. INSTALL HYBRID BATTERY TERMINAL BLOCK CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Engage the claw to install the hybrid battery terminal block to the HV battery. (b) Connect the hybrid battery terminal block connector. NOTICE: Make sure that the co
© 2016-2026 Copyright www.lexguide.net
