Lexus ES manuals

Lexus ES: Absorber Control Actuator(for Front Side)

Lexus ES (XZ10) Service Manual / Suspension / Suspension Control / Absorber Control Actuator(for Front Side)

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT ABSORBER CONTROL ACTUATOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

15 to 25°C

3.3 to 3.7 Ω

If the result is not as specified, replace the front shock absorber assembly.

*a

Component without harness connected

(Absorber Control Actuator)

READ NEXT:

 Absorber Control Actuator(for Rear Side)

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester C

 Absorber Control Switch

ComponentsCOMPONENTS ILLUSTRATION *1 DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) - - RemovalREMOVAL PROCEDURE 1. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY)

 Adaptive Variable Suspension System

SEE MORE:

 Automatic High Beam Switch Indicator does not Come ON

DESCRIPTION When the automatic high beam system is on, the steering sensor illuminates the automatic high beam switch indicator. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d

 Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) (a) Install a new gasket to t

© 2016-2026 Copyright www.lexguide.net