Lexus ES: Power Window Control System (for Hv Model)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Window / Glass / Power Window Control System (for Hv Model)
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Power Window Motor Malfunction (B2311)
- Power Window Switch Malfunction (B2312)
- Glass Position Initialization Incomplete (B2313)
- Driver Side Power Window does not Operate with Power Window Master Switch
- Remote Up / Down Function does not Operate
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH does not Operate with Rear Power Window Switch LH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
- Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
- Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
- All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
- Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)
- Jam Protection Function does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *2 COMBINATION METER ASSEMBLY *3 DLC3 *4 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *5 INSTRUMENT PA
System Description
SYSTEM DESCRIPTION POWER WINDOW CONTROL SYSTEM DESCRIPTION (a) The power window control system controls the power window operation using the power window regulator motor assemblies. The main controls
SEE MORE:
Control Module Communication Bus "B" Off Bus Off (U007488,...,U015187)
DESCRIPTION The skid control ECU (brake actuator assembly) communicates with the following ECUs and sensors via CAN communication.
ECM
TCM (ECM)
Yaw rate and acceleration sensor (airbag ECU assembly)
Steering angle sensor
Power steering ECU (rack and pinion power steering gear assembly)
Installation
INSTALLATION PROCEDURE 1. INSTALL ENGINE COVER BRACKET (a) Install the engine cover bracket to the cylinder head cover sub-assembly LH with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL WATER FILLER BRACKET (a) Temporarily install the water filler bracket to the camshaft housing
© 2016-2026 Copyright www.lexguide.net
