Lexus ES: Power Window Control System (for Hv Model)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Window / Glass / Power Window Control System (for Hv Model)
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Power Window Motor Malfunction (B2311)
- Power Window Switch Malfunction (B2312)
- Glass Position Initialization Incomplete (B2313)
- Driver Side Power Window does not Operate with Power Window Master Switch
- Remote Up / Down Function does not Operate
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH does not Operate with Rear Power Window Switch LH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
- Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
- Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
- All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
- Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)
- Jam Protection Function does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *2 COMBINATION METER ASSEMBLY *3 DLC3 *4 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *5 INSTRUMENT PA
System Description
SYSTEM DESCRIPTION POWER WINDOW CONTROL SYSTEM DESCRIPTION (a) The power window control system controls the power window operation using the power window regulator motor assemblies. The main controls
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (a) Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut. NOTICE:
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nu
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY HINT: Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly. Click here (a) Read the value of Data List item "Mass Air Flow Sensor" using the Techstream. NOTICE: Perform the inspection of t
© 2016-2026 Copyright www.lexguide.net
