Lexus ES: Power Window Control System (for Gasoline Model)
Lexus ES (XZ10) Service Manual / Vehicle Interior / Window / Glass / Power Window Control System (for Gasoline Model)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Power Window Motor Malfunction (B2311)
- Power Window Switch Malfunction (B2312)
- Glass Position Initialization Incomplete (B2313)
- Remote Up / Down Function does not Operate
- Driver Side Power Window does not Operate with Power Window Master Switch
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH does not Operate with Rear Power Window Switch LH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
- Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
- Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH
- Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
- All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)
- Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
Parts Location
PARTS LOCATION ILLUSTRATION *1 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *2 COMBINATION METER ASSEMBLY *3 DLC3 *4 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *5 INSTRUMENT PA
System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method Multiplex Network Master Switch Assembly Power Window Regulator Motor Assembly (for Driv
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front axle hub sub-assembly on-vehicle inspection are shown below. Necessary Procedures A
Operation Check
OPERATION CHECK REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK NOTICE:
Before entering self-diagnostic mode, make sure there are no obstructions which may interfere with operation of the remote touch screen, and that the remote touch screen is not dirty.
Do not touch the remote
© 2016-2026 Copyright www.lexguide.net
