Lexus ES: Problem Symptoms Table
Lexus ES (XZ10) Service Manual / Vehicle Interior / Mirror (ext) / Power Mirror Control System (for Gasoline Model Without Memory) / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
If the battery voltage is low, the mirror heater function may not operate.
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| Electrical remote control mirror does not operate | Outer mirror switch assembly | |
| Outer rear view mirror assembly LH | | |
| Outer rear view mirror assembly RH | | |
| Wire harness or connector | - | |
| Mirror heater does not operate | Proceed to "Mirror Heater does not Operate with Rear Defogger Switch" | |
| Automatic glare-resistant EC mirror does not operate | Inner rear view mirror assembly | |
| Outer rear view mirror assembly LH | | |
| Outer rear view mirror assembly RH | | |
| Wire harness or connector | - |
.gif)
READ NEXT:
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the battery voltage. Standard Voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace th
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY Click here
Data List / Active Test
DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive func
SEE MORE:
Motor Electronics Coolant Pump "A" Component Internal Failure (P0C7396)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC is stored when the inverter water pump assembly is malfunctioning. The cause of this malfunction may be one of the following: Inverter water pump assembly malfunction
Inverter water pump assembly internal malfunction
Open or short in wire harness
I
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT AXLE OUTBOARD JOINT BOOT (a) Secure the drive shaft in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (
© 2016-2026 Copyright www.lexguide.net
