Lexus ES: Power Mirror Control System (for Hv Model With Memory)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Mirror (ext) / Power Mirror Control System (for Hv Model With Memory)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Lost Communication With Body Control Module "B" (U0142)
- Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Power Mirror cannot be Adjusted with Power Mirror Switch
- Mirror Heater does not Operate with Rear Defogger Switch
- Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
- AUTO Power Retract Mirrors do not operate
- Power Mirror Surface Position is not Memorized
- Power Mirrors do not Return to Memorized Position
- Reverse Shift-linked Function of Power Mirrors does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 OUTER REAR VIEW MIRROR ASSEMBLY (DRIVER DOOR) *2 OUTER REAR VIEW MIRROR ASSEMBLY (FRONT PASSENGER DOOR) *3 OUTER MIRROR (DRIVER DOOR) *4 OUTER MIRROR
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Outer Mirror Control ECU Assembly
IG signal
ACC signal
Outer mirror
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP WITH AIR CLEANER HOSE *2 THROTTLE BODY GASKET *3 THROTTLE BODY WITH MOTOR ASSEMBLY *4 VACUUM HOSE *5 NO. 1 FUEL VAPOR FEED HOSE *6 NO. 2 VENTILATION HOSE *7 NO. 2 WATER BY-PASS HOSE *8 NO. 3 WATER BY-PASS HOSE
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below. Necessary Procedure After Parts Removed
© 2016-2026 Copyright www.lexguide.net
