Lexus ES: Mirror (ext)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Mirror (ext)
- Outer Mirror Control Ecu
- Outer Mirror Switch
- Outer Rear View Mirror
- Outer Rear View Mirror Cover
- Outer Rear View Mirror Glass
- Power Mirror Control System (for Gasoline Model With Memory)
- Power Mirror Control System (for Gasoline Model Without Memory)
- Power Mirror Control System (for Hv Model With Memory)
- Power Mirror Control System (for Hv Model Without Memory)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 COURTESY LIGHT ASSEMBLY *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY *3 MULTIPLEX NETWORK MASTER SWITCH ASS
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE NO. 2 DOOR TRIM PAD Click here 2.
SEE MORE:
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Sliding Roof ECU (Sliding Roof Drive Gear Assembly)
Sliding roof operation permission signal
IG signal
Front door courtesy light switch assembly signal
Vehicle speed
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. Lithium Soap Base Glycol Grease (b) Install the No. 2 steering rack boot to the groove on the rack housing. NOTICE:
Be
© 2016-2026 Copyright www.lexguide.net
