Lexus ES: Power Mirror Control System (for Gasoline Model With Memory)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Mirror (ext) / Power Mirror Control System (for Gasoline Model With Memory)
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Customize Parameters
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- Dtc Check / Clear
- Diagnostic Trouble Code Chart
- Lost Communication With Body Control Module "B" (U0142)
- Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
- Power Mirror cannot be Adjusted with Power Mirror Switch
- Mirror Heater does not Operate with Rear Defogger Switch
- Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
- AUTO Power Retract Mirrors do not operate
- Power Mirror Surface Position is not Memorized
- Power Mirrors do not Return to Memorized Position
- Reverse Shift-linked Function of Power Mirrors does not Operate
- Reverse Shift-linked Function of Power Mirrors does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
Parts Location
PARTS LOCATION ILLUSTRATION *1 OUTER REAR VIEW MIRROR ASSEMBLY (DRIVER DOOR) *2 OUTER REAR VIEW MIRROR ASSEMBLY (FRONT PASSENGER DOOR) *3 OUTER MIRROR (DRIVER DOOR) *4 OUTER MIRROR
System Description
SYSTEM DESCRIPTION POWER MIRROR CONTROL SYSTEM (w/ Memory) DESCRIPTION (a) This system has the following functions: electrical remote control mirror function, memory and reactivation function, power r
SEE MORE:
Image from Camera for Panoramic View Monitor is Abnormal
DESCRIPTION The display signal from each camera is transmitted to the multi-display assembly via the parking assist ECU. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, cor
Installation
INSTALLATION PROCEDURE 1. INSTALL BATTERY STATE SENSOR ASSEMBLY (a) Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder. (b) Connect the battery state sensor assembly connector. (c) Install the battery state sensor assembly to the auxiliary battery an
© 2016-2026 Copyright www.lexguide.net
