Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL BATTERY STATE SENSOR ASSEMBLY
(a) Engage the 2 claws to install the battery state sensor assembly to the battery current sensor holder.
(b) Connect the battery state sensor assembly connector.
(c) Install the battery state sensor assembly to the auxiliary battery and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(d) Connect the No.2 frame wire to the battery state sensor assembly with the nut.
Torque:
7.6 N·m {77 kgf·cm, 67 in·lbf}
NOTICE:
When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
Click here .gif)
(e) Return the luggage compartment trim cover RH to its original position.
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during batt
Components
COMPONENTS ILLUSTRATION *1 BATTERY STATE SENSOR ASSEMBLY *2 WIRE HARNESS *3 BATTERY CURRENT SENSOR HOLDER *4 NO.2 FRAME WIRE Tightening torque for "Major areas involving bas
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Active Noise Control System DTC No. Detection Item Link B1AA044 ANC ECU EEPROM Data Memory Failure B1AA187 UART Communication Between ANC and Audio Amplifier Missing Message B1AA296 Front Left Microphone Circuit Component Internal Fail
Operation Check
OPERATION CHECK CHECK AUTO OPERATION FUNCTION NOTICE:
Make sure that initialization has been completed before performing this inspection.
Click here
The sliding roof auto operation can be customized. Make sure that the auto operation customize setting is set to ON.
Click here HINT: When
© 2016-2026 Copyright www.lexguide.net
