Lexus ES: Panoramic Moon Roof System
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Sliding Roof / Convertible / Panoramic Moon Roof System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Sensor (Motor) Failure (B2341,B2344)
- Switch Failure (B2342)
- Position Initialization Incomplete (B2343)
- Motor Control Relay Stuck ON (B2345)
- Lost Communication with Front Shade Module (B2346)
- Sensor (Motor) Failure (Fr Shade) (B2347,B2349)
- Position Initialization Incomplete (Fr Shade) (B2348)
- Motor Control Relay Stuck ON (Fr Shade) (B234A)
- Remote Control System does not Operate
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Panoramic Moon Roof System does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cab
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for LH) *2 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for RH) *3 ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR AS
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Sliding Roof ECU (Sliding Roof Drive Gear Assembly)
Sliding roof operati
SEE MORE:
Hybrid/EV Battery Voltage Isolation Sensor Circuit Internal Electronic Failure (P0AA749)
DESCRIPTION The hybrid vehicle control ECU monitors the insulation monitoring circuit located in the battery ECU assembly and detects malfunctions. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0AA749 Hybrid/EV Battery Voltage Isolation Sensor C
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Click here 2. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Disconnect the drive mode select switch (combination switch assembly) connector. (b) Disengage the clamp to disconnect the wire harne
© 2016-2026 Copyright www.lexguide.net
