Lexus ES: Lighting (ext)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext)
- Automatic Light Control Sensor
- Hazard Warning Switch
- Headlight Assembly (for Bulb Type Turn Signal Light)
- Headlight Assembly (for Led Type Turn Signal Light)
- Headlight Dimmer Switch
- Headlight Ecu
- Height Control Sensor
- High Mounted Stop Light Assembly
- Illumination Light Assembly (for Front Door)
- Illumination Light Assembly (for Rear Door)
- License Plate Light Assembly
- Lighting System (for Gasoline Model)
- Lighting System (for Hv Model)
- Rear Combination Light Assembly
- Rear Light Assembly
- Relay
- Side Turn Signal Light Assembly
- Stop Light Switch
- Switch Housing
READ NEXT:
Automatic Light Control Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 AUTOMATIC LIGHT CONTROL SENSOR *2 NO. 1 SPEAKER OPENING COVER ASSEMBLY On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIG
Components
COMPONENTS ILLUSTRATION *A w/o Headup Display *B w/ Headup Display *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR OPENING TRIM COVER LH *3 FRONT DOOR SCUFF PLATE LH *4 HAZARD W
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY (a) Engage the 4 guides and 2 claws to install the side turn signal light assembly. 2. INSTALL OUTER
Internal Control Module Monitoring Processor Performance Watchdog/Safety MCU Failure (P060A47)
MONITOR DESCRIPTION The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, this DTC is stored. DTC No. Detection Item DTC Detection Condition
© 2016-2026 Copyright www.lexguide.net
