Lexus ES: Side Turn Signal Light Assembly
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Lighting (ext) / Side Turn Signal Light Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o Panoramic View Monitor System *B w/ Panoramic View Monitor System *1 OUTER MIRROR *2 OUTER MIRROR COVER ASSEMBLY *3 OUTER MIRROR LOWER COVER
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during sid
Inspection
INSPECTION PROCEDURE 1. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY LH *a Component without harness connected (Side Turn Signal Light Assembly LH) (a) Apply auxiliary battery voltage to the side
SEE MORE:
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio receiver assembly, alw
Remote Service Malfunction
PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Bus Check. Click here (e) Check that all ECUs and sensors that use CAN communication are connected. Resul
© 2016-2025 Copyright www.lexguide.net
