Lexus ES: Hv Battery Stack (for Lithium-ion Battery)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Hv Battery Stack (for Lithium-ion Battery)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BATTERY ECU ASSEMBLY *2 UPPER HV BATTERY COVER SUB-ASSEMBLY *3 NO. 1 HV BATTERY HOSE - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUST
Basic Inspection
DESCRIPTION When replacing the No. 1 HV supply stack sub-assembly or No. 2 HV supply stack sub-assembly, it is necessary to check, adjust and equalize the SOC of the HV battery. Otherwise, the engine
Inspection
INSPECTION PROCEDURE 1. INSPECT HV SUPPLY STACK SUB-ASSEMBLY CAUTION: Be sure to wear insulated gloves and protective goggles. (a) Remove the HV supply stack sub-assembly. Click here (b) Inspect th
SEE MORE:
Utility
UTILITY NOTICE:
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE NO. 2 DOOR TRIM PAD Click here 2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver
© 2016-2026 Copyright www.lexguide.net
