Lexus ES: Front Drive Shaft Assembly (for A25a-fks)
Lexus ES (XZ10) Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Front Drive Shaft Assembly (for A25a-fks)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT FENDER APRON SEAL LH *2 FRONT FENDER APRON SEAL RH *3 FRONT WHEEL OPENING EXTENSION PAD LH *4 FRONT WHEEL OPENING EXTENSION PAD RH *5 NO. 1 E
Disassembly
DISASSEMBLY PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Secure the drive shaft in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Using pliers, sepa
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the outboard joint. (b) Check that the inboard joint slid
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT LENS AND BODY LH (for TMC Made) *a Component without harness connected (Rear Combination Light Lens and Body LH) (a) Apply auxiliary battery voltage to the rear combination light lens and body LH and check that the lights illuminate. OK
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension member sub-assembly removal/installation are shown below. Necessary Procedures After Pa
© 2016-2026 Copyright www.lexguide.net
