Lexus ES: Drive Shaft / Propeller Shaft
Lexus ES (XZ10) Service Manual / Drivetrain / Drive Shaft / Propeller Shaft
- Drive Shaft System
- Front Drive Shaft Assembly (for 2gr-fks)
- Front Drive Shaft Assembly (for A25a-fks)
- Front Drive Shaft Assembly (for A25a-fxs)
- Propeller Shaft Assembly
- Propeller Shaft System
- Rear Drive Shaft Assembly
READ NEXT:
Drive Shaft System
PrecautionPRECAUTION NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (for AWD) (a) When removing and installing the front drive shaft assembly RH in an AWD vehicle, be sure to first d
Components
COMPONENTS ILLUSTRATION *A for Type A *B for Type B *1 FRONT FENDER APRON SEAL LH *2 FRONT FENDER APRON SEAL RH *3 FRONT WHEEL OPENING EXTENSION PAD LH *4 FRONT WHEEL OPE
SEE MORE:
O2 Sensor Slow Response - Rich to Lean Bank 1 Sensor 1 (P014C00,P014D00,P015A00,P015B00)
DESCRIPTION Refer to DTC P003012. Click here HINT: Although the DTC titles say O2 sensor, these DTCs relate to the air fuel ratio sensor (sensor 1). DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P014C00 O2 Sensor Slow Response - Rich to Lean Bank
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE NO. 2 DOOR TRIM PAD Click here 2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver
© 2016-2025 Copyright www.lexguide.net
