Lexus ES: Battery Cooling Filter
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
NO. 1 HV BATTERY INTAKE FILTER
*2
BATTERY SERVICE HOLE COVER
REMOVAL
PROCEDURE
1. REMOVE BATTERY SERVICE HOLE COVER
(a) Remove the clip.
Remove in this Direction
(b) Disengage the 7 claws as shown in the illustration.
(c) Di
INSPECTION
PROCEDURE
1. INSPECT NO. 1 HV BATTERY INTAKE FILTER
HINT:
If the vehicle is used in an area with heavy traffic or excessive dust,
or if the rear seat is used frequently, the
SEE MORE:
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL RH Click here 2. REMOVE FRONT FENDER APRON SEAL RH Click here 3. REMOVE V-BANK COVER SUB-ASSEMBLY Click here 4. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 2) Click here 5. SET NO. 1 CYLINDER TO TDC/COMPRESSION
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear differential carrier assembly removal/installation are shown below. Necessary Procedures After Par
© 2016-2024 Copyright www.lexguide.net