Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 HV BATTERY INTAKE FILTER
(a) Engage the 2 claws to temporarily install the No. 1 HV battery intake filter to the battery service hole cover.
(b) Engage the 3 claws to install the No. 1 HV battery intake filter to the battery service hole cover.
2. INSTALL BATTERY SERVICE HOLE COVER
(a) Engage the guide and 7 claws.
(b) Install the battery service hole cover with the clip.
3. CLEAR DTC
HINT:
If the message "Maintenance Required for Traction Battery Cooling Parts See Owner's Manual" is displayed on the multi-information display, clean or replace the No. 1 HV battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.
Click here .gif)
READ NEXT:
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 HV BATTERY INTAKE FILTER
(a) Engage the 2 claws to temporarily install the No. 1 HV battery intake filter
to the battery service hole cover.
(b) Engage th
Brake Fluid (for Gasoline Model)
Components
COMPONENTS
ILLUSTRATION
*1
BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
-
-
ILLUSTRATION
*1
FRON
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT DRIVE SHAFT BEARING (for RH Side) (a) Using SST, a steel plate and a press, install a new front drive shaft bearing. SST: 09527-10011 NOTICE: The bearing should be completely installed. *a Steel Plate (b) Using a snap ring expander,
Dynamic radar cruise control with
full-speed range
In vehicle-to-vehicle distance control
mode, the vehicle automatically
accelerates, decelerates and
stops to match the speed changes
of the preceding vehicle even if the
accelerator pedal is not depressed.
In constant speed control mode,
the vehicle runs at a fixed speed.
Use the dynamic
© 2016-2026 Copyright www.lexguide.net
