Lexus ES: Installation

Lexus ES (XZ10) Service Manual / General / Maintenance / Battery Cooling Filter / Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 1 HV BATTERY INTAKE FILTER

(a) Engage the 2 claws to temporarily install the No. 1 HV battery intake filter to the battery service hole cover.

(b) Engage the 3 claws to install the No. 1 HV battery intake filter to the battery service hole cover.

2. INSTALL BATTERY SERVICE HOLE COVER

(a) Engage the guide and 7 claws.

(b) Install the battery service hole cover with the clip.

3. CLEAR DTC

HINT:

If the message "Maintenance Required for Traction Battery Cooling Parts See Owner's Manual" is displayed on the multi-information display, clean or replace the No. 1 HV battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.

for NICKEL METAL HYDRIDE BATTERY:
Click here
for LITHIUM-ION BATTERY:
Click here

SEE MORE:

Brake Vacuum Hose (for Gasoline Model)

ComponentsCOMPONENTS ILLUSTRATION *1 FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) N*m (kgf*cm, ft.*lbf): Specified torque *T1 Bolt colo

Inspection

INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Auto Wiper System) (a) Measure the resistance according to the value(s) in the table below. *A for Type A *B for Type B *a Component without harness connected (Windshield Wiper Switch Assembly) - - HINT: If t

Lexus ES: Installation

READ NEXT:

Brake Fluid (for Gasoline Model)

Brake Fluid (for Hv Model)

Components

SEE MORE:

Brake Vacuum Hose (for Gasoline Model)

Inspection